#Halogen vs led vs hid evo x how to#

Hope that helps a little bit more, and I know I need to look at the sticky on how to post pics and stuff, sorry for any confusion. Haven't done a major water test on her yet.but a big storm is coming tomorrow, Cant Wait!!! :-) (Pic 6)įinished product (Pic 7) I just ran the plug through the hole already in the rubber boot. Next mushroom out the heatsink as shown, keeping in mind that the rubber boot Will go back on. Then lock down the LED with retaining spring (pic 5) Remove old lamp and install LED in its place. Back out the screw enough to get the spring out, you don't need to remove it. One side is held by that black screw (yellow arrow) and the other side rests under the housing (red arrow). Rubber boot off (Pic 4) This is the retaining spring, pay careful attention to how it Fits. This is what the back of your assembly should look like (Pic3) Notice the rubber boot is still attached and the lamp plug (3 spade bits) can be seen in the middle of the boot Remove the screw in the fender well that secures the bumper as well (2nd Pic) This will enable you to 'pull' the bumper out enough to remove the 2 bolts under the lamp hidden by the bumper. Look at pic, the yellow locates the trim clips that need to be removed (all 4 that hold on the 'grill' area should be removed) And the red shows the location of the lower right bolt holding the lamp assy to the car. Ok so first off I removed the entire headlight assembly, some people remove the bumper to do this I just pulled it out of the way a bit to get to the screws holding in the assy.

Halogen vs led vs hid evo x